Oregon-scientific RMR603HGA Uživatelský manuál Strana 1

Wireless Thermo-Hygro ClockModel : RMR603HGAUser ManualRMR603HGA lab test cover R2 1/14/04, 1:31 AM1

EN9TURN ATOMIC CLOCK ON/OFFPerform this step if you cannot receive Atomic Clocksignals. Press and hold ZONE for 2 seconds. Then,manually set the cloc

EN10ACTIVATE ALARMPress ((.)) to activate or deactivate the Alarm. showsin the Clock Area when the Alarm is activated.SNOOZE ALARMPress SNOOZE/LIGH

EN11If you use a sensor that collects onlytemperature data, humidity will not be shown.MINIMUM / MAXIMUM RECORDSPress MEM to toggle between current, m

EN12WARNINGSThis product is designed to give you years of service ifhandled properly. Observe the following guidelines:• Never immerse the product in

EN13SPECIFICATIONSMAIN UNIT DIMENSIONSL x W x H116 x 125 x 57 mm(4.57 x 4.92 x 2.24 inches)Weight 7.90 ounces with batteryREMOTE SENSOR DIMENSIONSL x

EN14FCC STATEMENTThis device complies with Part 15 of the FCC Rules.Operation is subject to the following two conditions:(1) This device may not cause

EN15DECLARATION OF CONFORMITYThe information below is not to be used as contact forsupport or sales. Please call our customer service number(listed on

© 2004 Oregon Scientific. All rights reserved.P/N.: 086-003347-01RMR603HGA lab test back cover 12/29/03, 10:29 PM1

EN1CONTENTSContents ... 1Introduction ...

EN2INTRODUCTIONThank you for selecting the Oregon ScientificTM WirelessThermo-Hygro Clock (RMR603HGA). This devicebundles precise time keeping, alarm,

EN3PRODUCT OVERVIEWFRONT VIEW1. SNOOZE / LIGHT: Press to activate backlight orsnooze.2. Temperature Area: Readings, trend line, sensorreception status

EN4BACK VIEW1. Wall mount2. Battery compartment3. °C / °F switch4. ZONE: Press to switch time zones,deactivate Atomic Clock signal reception5. RESET h

EN5REMOTE SENSOR (THGR122NX)1. LCD display2. LED Status indicator1212341. Wall mount hole2. RESET3. Channel number (1 - 3)4. Battery compartment(Batte

EN6CHANGE SETTINGS1. Press and hold MODE for 2 seconds to enter settingmode.2. Press UP or DOWN to change settings.3. Press MODE to confirm.TABLE STAN

EN73. Place the sensor near the main unit. Press RESETon the sensor to initiate signal sending between thesensor and the main unit. The reception icon

EN8SEARCH FOR SENSORTo search for a sensor, press and hold MEM andCHANNEL for 2 seconds.If the sensor is still not found, check thebatteries, obstru