Oregon-scientific Wireless Thermo Clock RMR602A Uživatelský manuál

Wireless Thermo ClockModel : RMR602AUser ManualRMR602A lab test cover R1 1/8/04, 6:51 PM1

EN9TURN ATOMIC CLOCK ON/OFFPerform this step if you cannot receive Atomic Clocksignals. Press and hold DOWN for 2 seconds. Then,manually set the cloc

EN10TEMPERATUREThis product can display current, maximum, andminimum temperature readings collected by the mainunit (indoor) and remote sensor (outdoo

EN11WARNINGSThis product is designed to give you years of service ifhandled properly. Observe the following guidelines:• Never immerse the product in

EN12SPECIFICATIONSMAIN UNIT DIMENSIONSL x W x H 100 x 47 x 99 mm(3.94 x 1.85 x 3.90 inches)Weight 4.80 ounces with batteryREMOTE SENSOR DIMENSIONSL x

EN13FCC STATEMENTThis device complies with Part 15 of the FCC Rules.Operation is subject to the following two conditions:(1) This device may not cause

EN14DECLARATION OF CONFORMITYThe information below is not to be used as contact forsupport or sales. Please call our customer service number(listed on

© 2004 Oregon Scientific. All rights reserved.P/N.: 086-003350-010RMR602A lab test back cover 12/29/03, 10:23 PM1Black

EN1CONTENTSContents ... 1Introduction ...

EN2INTRODUCTIONThank you for selecting the Oregon ScientificTM WirelessThermo Clock (RMR602A). This device bundles precisetime keeping, alarm, and tem

EN3MODEMEMPRODUCT OVERVIEWFRONT VIEW1. Outdoor Temperature Area: Readings, sensorbattery and reception status2. Indoor Temperature Area: Readings and

EN4BACK VIEWBACK VIEW1. Wall mount2. Battery compartment3. °C / °F switch4. RESET hole5. SEARCH button6. Table standREMOTE SENSOR (THGR122N)GETTING ST

EN51. LED Status indicator1. Wall mount hole2. Battery compartment3. Battery compartment cover112, 3REMOTE SENSORRMR602A lab test R2 1/17/04, 4:49 PM5

EN6CHANGE SETTINGS1. Press and hold MODE for 2 seconds to enter settingmode.2. Press UP or DOWN to change settings.3. Press MODE to confirm.TABLE STAN

EN7SETUP SENSOR1. Open the remote sensor battery compartment witha small Phillips screwdriver.2. Insert the batteries, matching the polarity as showni

EN8SEARCH FOR SENSORTo search for the sensor, press SEARCH . The SEARCHbutton is located in the main unit battery compartment.If the sensor is still n